Control
Last updated
Last updated
Go to the settings and select the Control category.
In this passage, the customizing possibilities for this panel are described.
Choose the appearance of the Toolhead motion controls. Available choices:
Have a combined button for homing the X&Y axes. Otherwise, there are two individual buttons.
This inverts the direction of the X axis, when moving through the interface.
This inverts the direction of the Y axis, when moving through the interface.
This inverts the direction of the Z axis, when moving through the interface.
Some users prefer to move the print bed instead of the toolhead. For example, in a CoreXY printer, when the option is active, moving Z in the negative direction sends the print bed down, away from the toolhead. Normally, the toolhead would move down towards the print bed when you move Z in the negative direction.
Set how fast the X&Y axes should move when controlled by the toolhead control.
Set how fast the Z axis should move when controlled by the toolhead control.
Customize the distances in mm the toolhead may travel. A maximum of 9 values are allowed.
Customize the distances in mm the Z offset can be adjusted. A maximum of 4 values are allowed.
In this passage, the customizing possibilities for this panel are described.
Define some presets of filament lengths for extruding via the interface.
Don't worry, you can also enter the value by hand in the panel itself.
Define some presets of extrusion speeds when extruding via the interface. After you figured out the maximum extrusion speed of your hotend, you may want to map it here.
Note that you can also enter this value directly in the panel.
This option allows you to hide the calculation in the extruder panel.
